Kontrol s8 driver for mac5/31/2023 ![]() On other Scarlett interfaces in the range that have a higher number of output channels, Focusrite Control can be used to adjust the routing of signals to the outputs. This is entirely normal with these models and does not stop audio from your computer from being played through the outputs on the Solo or 2i2.Įnabling Direct Monitor by pressing the Direct Monitor button on the front panel of these interfaces will also route the hardware inputs directly to the outputs. If you connect a Scarlett Solo or 2i2 3rd Gen to your computer and open the Output Routing tab in Focusrite Control, you'll see the message "Output routing is not supported on this device". This is because these devices only have two output channels and stereo playback from software on your computer will be automatically routed to the stereo outputs on the interface. It is therefore correct to see the message 'Output Routing is not Supported on this Device'. When using the Scarlett Solo or 2i2 3 rd Gen, the Output Routing section in Focusrite Control is not used. ![]() Applies to: Scarlett Solo and 2i2 3 rd Gen
0 Comments
Leave a Reply. |